-40%
Softub Pump 1hp, (1.5hp SPL) With Thermal Wrap Heat Jacket (replaces coil wrap)
$ 194.83
- Description
- Size Guide
Description
Softub Pump Replacement: 1.5HP (SPL) 12 Amps, Single (1) Speed with Thermal Wrap Heater Jacket by Hydro ThermixThe wet end/pump (Balboa/Vico) used with this system is the very same once used by Softubs.
Replacement pump and motor with the Thermal Wrap serves as the only heat source for many spa brands.
Retro-fit kits available for most all Softub applications.
Softub Hot Tub Pump Replacement - 1 HP -
"Front Discharge", Single Speed
with Pre-Installed "Thermal Wrap" Heater Jacket
NOTE: Also search item number: 112216516367 for Aqua Flo threaded pump version Softub pump
Please visually verify your pump connection configuration before ordering.
(Complete as shown in first picture)
This system is designed to replace your existing coil wrapped motor with our patented "Thermal Wrap" Heat Jacket - for less money!
This System/Listing Includes:
Motor & Pump with Pre-Installed Thermal Wrap
Descriptions:
Motor:
Mfg: Century - Single Speed Motor
HP: 1 - Service factor 1.0 (1.5hp SPL)
RPM: 3450
Single Speed
115 Volts
12 amps
HZ: 60
Frame: 56Z (48Y)
Thermally Protected
Pump: (pre-installed on motor)
Mfg: Vico/Balboa - Front Discharge - No threaded connections on pump end.
1 HP (1.5HP SPL)
Bottom Suction x Front Discharge
Pump ports measure 2 1/4" diameter and fit your existing plumbing connections.
Note: Also available with (Center Suction x Side Discharge) and (Center Suction x Center Discharge)
Please visit our eBay store to view your pump configuration.
____________________________________________________
More about the Thermal Wrap - Heat Transfer System:
Tub water circulates through a serpentine path in the Thermal Wrap, collecting the heat generated by the pump/motor and recycles that heat to the tub water - were it belongs!
This patented heating system for hot tubs/spas and Whirlpool Baths, captures and recycles the waste heat "energy" produced by the pump/motor and delivers that heat to the hot tub or bath water. The Thermal Wrap system will heat and maintain water temperature. The system allows the motor to run cooler; increasing the motors longevity and efficiency. There are no moving parts and nothing to wear out. Made in the USA!
Efficient:
- Patented design, over 1,000,000 in use
- Special thermal conductive inner heat transfer liner
- Models available for most 48 frame thru bolt spa/hot tub and jetted bathtub pumps
Economical:
- Maintenance free - no moving parts to wear out
- Helps keep motor cooler - increases motor longevity and efficiency
- Cost less than electric heaters
- No additional electrical circuits required for installation
Safe:
- Manufactured of non-conductive materials
- Non electrical
- Self draining design (required for whirlpool bath application)
Quantum, Dreammaker, FreeFlo, PDC spas, Softub and others.
Can be used and retrofitted to work with most spas requiring 1 hp single speed, 3450 rpm, 115volts pump motor.
Even if you have an electric heater on your spa, the Thermal Wrap System will compliment your electric heater by capturing
the waste heat generated by your pump motor and delivering that heat to the tub water,
saving you money with heating costs.
The Thermal Wrap will help maintain water temperature during normal filtering and heating cycles and while using your spa in high speed jet action.
Visit our eBay Store for more pumps, motors and controls for hot tubs.
Please contact us for international shipping costs.
Thank you!